Raised-panel steel
Carriage house
Modern flush
Full-view glass
LiftMaster openers
Chamberlain openersFull 25-point door and opener safety check with every visit - springs, cables, rollers, tracks, and your LiftMaster or Chamberlain opener included
You get a price before we start. It does not change when the pro arrives.
Get your free estimateFast, Reliable Garage Door Installation Across Arlington
If your garage is one of Arlington’s older single-car structures – a narrow 1920s – 1950s detached garage in Lyon Village, Ashton Heights or Cherrydale – the door on it has probably outlived its springs, its opener, and possibly its framing. Installing a new one there is a custom-fit job, not a panel swap. We know these blocks, we know the low-headroom quirks of the old stock, and we work on the door and opener systems those garages actually hold. Call (877) 379-9603 for a free estimate. We’ll measure the opening, check the framing and headroom, and give you a written price before anything is ordered.
Why Arlington Homeowners Call Alexandria Garage Door Repair Pros for Garage Door Installation
Garage doors are the only thing we do. Every technician we connect you with works on doors full time – springs, cables, openers, panels, new installs – so the diagnosis you get on an Arlington garage is coming from someone who has seen a hundred like it, not a generalist squeezing a door in between a fence and a bathroom remodel.
That matters most in Arlington’s legacy stock. An original solid-wood door that has swollen and stuck through humid summers and then rattled in freeze-thaw winters usually has tired torsion springs, worn drums and cables well past their rated cycles, and a stock opener straining to lift weight the springs should be carrying. We read that whole system before quoting. We’re factory-familiar with the brands already in those garages, including LiftMaster, Craftsman and Wayne Dalton, so we aren’t guessing at what a previous owner installed. We serve Arlington from a single-trade specialty, which means the person who measures your opening is the same kind of specialist who’ll set the new door.
We also work the neighborhoods around you: the narrow lots near Clarendon and Ballston, the older detached garages off the Ashton Heights grid, the additions that have gone in around Seven Corners. Installation is measured, ordered and scheduled – no same-day promise on a new door – but the quote is free and the price is agreed before work starts.
Styles & brands we work with
- Raised-panel steel
- Carriage house
- Modern flush
- Full-view glass
- LiftMaster openers
- Chamberlain openers
Our Garage Door Installation Services in Arlington
Installation in Arlington splits two ways: new-door projects on the older single-car garages and replacements on the newer infill townhomes. Both run through our garage door installation team.
New Door Installation
A new door installation in Arlington needs the opening measured to the inch and the headroom checked before anything ships. On the older narrow 8 – 9 ft openings, that measurement is what decides whether a stock sectional works or a custom-fit is required. A typical new door installation in Arlington runs $700 – $2,200, and the written estimate sets the final price.

Single Car Door
Most Arlington garage work is on a single-car door – often a narrow original opening framed into a structure built long before modern overhead doors existed. We treat the frame and the door as one system, because on these garages it is. If the end bearing plates or jambs are past it, we tell you before ordering.

Double Car Door
Double car doors show up mostly in the newer townhomes and renovations around Clarendon and Ballston, where there’s the width and headroom for a standard sectional. That’s the minority of Arlington work, but it’s real, and it’s where a straightforward replacement usually goes fastest.

Custom Garage Door
Custom-fit is the default on Arlington’s older stock. When an opening is 8 – 9 ft, the headroom is 6 – 7 ft under a shallow-pitch roof, and the original structure was never built for a modern overhead door, a custom door and reinforcement of the opening is the honest answer. We build the quote around your structure, not a catalog page.
Trusted Brands We Service in Arlington
We work on the brand already in your garage – LiftMaster, Chamberlain, Genie, Clopay, Amarr, Wayne Dalton, Craftsman and Raynor among them – so the door or opener we recommend matches what your Arlington garage already supports. We don’t stock parts or keep a warehouse; our specialty is knowing the systems and ordering what the job requires, not holding inventory. On an install, that means we specify the correct door, torsion setup and opener for your structure and get it right the first time you quote. Parts availability for old hardware varies by model, and we’ll tell you upfront if a legacy opener is better replaced than repaired.
See the difference
Before
After
Before
After
Before
AfterCommon Garage Door Installation Problems We See in Arlington Homes
- Solid-wood doors swelling and sticking. Arlington’s humid subtropical summers make an original wood door bind in July, then shrink and rattle in freeze-thaw winter, throwing the door off balance and overloading already-tired torsion springs.
- Legacy springs and openers past their cycles. Many 1920s – 1960s single-car garages still run original extension-spring setups and old openers that strain against weight the springs should be carrying. These are fatigued well past their rated spring cycles.
- Low headroom rejecting stock doors. Lyon Village and Ashton Heights garages often sit under a low, shallow-pitch roof with only 6 – 7 ft of headroom, so a stock 7-foot sectional won’t fit without a low-headroom torsion conversion. Homeowners find this out after ordering a door online.
- Steel bottom sections rusting and debris in tracks. Steel doors sweat and rust at the bottom section through Arlington winters, and wind-blown debris from summer thunderstorms and winter nor’easters works into exposed tracks and weather seal.
Pricing for Garage Door Installation in Arlington, VA
We quote per job after measuring, because on Arlington’s older garages the framing and headroom drive the price more than the door does. These are the typical estimated ranges we work from; the written estimate sets the final price, and the price is agreed before any work starts.
| Service | Typical Arlington Range |
|---|---|
| New Door Installation | $700 – $2,200 |
| Panel Replacement | $250 – $500 |
| Track Realignment | $120 – $240 |
| Spring Repair (one spring) | $180 – $340 |
| Opener Installation | $250 – $550 |
Spring repair is priced for one spring; a matched pair is usually replaced together, so a pair costs about twice that range. Estimates are free – call (877) 379-9603.
We Also Serve Cities Near Arlington
We install and service doors in the communities near Arlington too: Bailey’s Crossroads, Lake Barcroft, Seven Corners and Lincolnia. Same specialty, same measured quote. We serve Arlington and these neighbors with the full range of new door and retrofit work. Whether you’re just inside the line or a few minutes out, the estimate is free and the price is set in writing before anything starts.
Serving Arlington, VA – Our Local Coverage Area
We serve Arlington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Garage Door Installation in Arlington
Usually not without a low-headroom torsion conversion. A stock 7-foot sectional needs more headroom than many Lyon Village and Ashton Heights garages have, so the honest fix is a low-headroom setup sized to your structure. Call (877) 379-9603 and we’ll measure it – estimates are free.
Replace it if the wood has swelled and shrunk through decades of Arlington summers and winters and the springs, drums and cables are past their rated cycles – that combination usually costs more to keep patching than a modern setup. If the framing is sound and only one section is failing, a panel replacement at $250 – $500 is the cheaper call. Call (877) 379-9603 for a measured recommendation.
The spring has to be matched to the door’s actual weight and the headroom you’ve got – on a low-headroom garage, that means a low-headroom torsion setup, not a stock extension spring. Spring work is hazardous; the springs are under dangerous tension, so this is a trained-pro job, not a DIY one. Call (877) 379-9603 and we’ll specify it correctly.
Because the springs, not the opener, should be carrying the door’s weight, and tired original springs are making the opener do the lifting. On a 1920s – 1960s single-car garage, that opener is working well past what it was built for, and it’ll fail sooner because of it. Call (877) 379-9603 – we’ll tell you whether to replace the springs or the opener first.
Yes, with a custom-fit and usually some re-framing and reinforcement, since the original structure was never built for a modern overhead door. We measure the true 8 – 9 ft opening and headroom and build the door and framing to suit. Call (877) 379-9603 for a free estimate and a written price before anything is ordered.
Written by the team at Alexandria Garage Door Repair Pros.